- 718 - .460(11.68) .420(10.6) .160(4.1) .140(3.6) .153(3.9) .146(3.7) .050(1.27) .5 min (12.7) spacing ac .035(0.9) .028(0.7) .600(15.24) .560(14.22) kbp201g thru kbp207g single phase 2.0 amps. glass passivated bridge rectifiers voltage range 50 to 1000 volts current 2.0 amperes f eatures ul recognized file # e-96005 glass passivated junction ideal for printed circuit board reliable low cost construction technique results in inexpensive product high temperature soldering guaranteed: 260 / 10 seconds at 5 lbs. ( 2.3 kg ) tension small size, simple installation leads solderable per mil-std-202, method 208 kbp dimensions in inches and (millimeters) m aximum ratings and electrical characteristics rating at 25 ambient temperature unless otherwise specified. single phase, half wave, 60 hz, resistive or inductive load. for capacitive load, derate current by 20% type number symbol kbp 201g kbp 202g kbp 203g kbp 204g kbp 205g kbp 206g kbp 207g unit s maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 v maximum rms voltage v rms 35 70 140 280 420 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 v maximum average forward rectified current @t a = 50 i (av) 2.0 a peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method ) i fsm 60 a rating for fusing (t<8.35ms) i 2 t 15 a 2 se c maximum instantaneous forward voltage @ 3.14a v f 1.2 v maximum dc reverse current @ t a =25 at rated dc blocking voltage @ t a =125 i r 10 500 ua ua typical thermal resistance (note) r ja r jl 25 8 /w operating temperature range t j -55 to +150 storage temperature range t stg -55 to +150 note: thermal resistance from junction to ambient and from junction to lead mounted on p.c.b. with 0.47 x 0.47? (12 x 12mm) copper pads.
- 719 - ratings and characteristic curves (kbp201g thru kbp207g) fig.4- typical reverse characteristics per bridge element 0 20 40 60 80 100 120 140 0.1 1 10 100 percent of rated peak reverse voltage. (%) tj=125 c 0 tj=25 c 0 fig.1- maximum non-repetitive forward surge current per bridge element peak for ward surge current . (a) 10 246 1 40 60 20 100 10 0 20 30 50 60 40 number of cycles at 60hz fig.2- maximum forward current derating curve average for ward current . (a) 20 40 60 80 100 120 140 150 0 2.0 1.5 1.0 0.5 ambient temperature. ( c) o fig.3- typical instantaneous forward characteristics per bridge element instantaneous for ward current . (a) 0.6 0.7 0.9 0.8 1.0 1.3 1.1 1.2 1.4 0.01 0.1 1 10 instantaneous forward voltage. (v) tj=25 c pulse width-300 s 1% duty cycle 0 instantaneous reverse current .( a)
|